USB - MITSUBISHI Q programming adapter

USB-QC30R2 is the programming cable in which USB interface provides both the serial connection and RS232 signal conversion. Under the control of computer-driven driver, the programming cable makes it possible for the computer's USB interface to simulate the traditional serial (known as COM interface), thus various existing programming software such as communications software, monitoring software and other applications can be normally used. The working power supply of this cable is directly from the USB port, but not the PLC programming interface. The two-color LED on the converter box indicates data’s transceiving status.
USB-QC30R2 is applicable to Mitsubishi Q series PLC (Q mode)

USB-QC30R2 programming cable simulate USB port as traditional serial port (usually COM3), which enables existing programming software(GX Developer) to communicate through simulated traditional port and PLC devices.

• Support USB-QC30R2 programming software version: GPP V4.0, GX Developer V7.0 and above.
• Fully compatible with USB V1.1 norms and USB CDC V1.1
• USB-bus powered, with current consumption of 50 mA
• Baud rate: 300 bps ~ 1Mbps automatically adapt to the standard baud rate
• Support UART data format: data bits: 7-8; stop bit: 1, 2; check-bit: odd / even / no parity
• Each PC only supports one USB cable programming
• Working temperature: -20 ~ +75 'C
• Color: black

USB-QC30R2 doesn’t support long distance communication.

Notes and Troubleshoot:

1. If the USB programming cable could not be detected when opening the PC, or some other outstanding issues occur, please replug it again.
2.USB to UART is plug and play USB device. When data are being transmitted, please don’t disconnect it.
3.Sometimes when Windows System failures or outstanding issues when plug or unplug the USB cable occur, please restart the computer and PLC.